NEO S-Series Library Service Manual
Replacing Parts
10400666-005
©2015-20 Overland-Tandberg
31
Remove Components
1.
Remove all tape magazines to reduce the unit’s weight.
•
If the OCP or RMI is working, remove the magazine as described in
Magazine with OCP or RMI on page 28
.
•
If the procedure fails or if the magazine needs to be opened while the power is off,
follow the procedure in
Remove the Magazine Manually on page 29
2.
If needed, power down the library by pressing the
power button
on the front panel.
3.
Label and remove the
cables
on the rear of the library.
Remove Old Base Chassis from Rack
WARNING:
It is recommended that a mechanical lifter (or at least two people) be used during
rack installation or removal to prevent injury.
WARNUNG:
Um Verletzungen zu vermeiden, empfehlen wir zur Rack-Installation oder -
Deinstallation die Nutzung einer mechanischen Hebehilfe (oder mindestens zwei Personen).
AVERTISSEMENT:
Pour éviter toute blessure il est recommande qu'un monte-charge (ou deux personnes
au moins) soit utilisé lors de l'installation ou de l'enlèvement du support.
1.
Release the
screws
on both side flanges that secure the Base Chassis to the rack.
2.
With a mechanical lifter positioned in front of the library, release the
rail locks
and
slide the
Base Chassis
out onto the lifter.
3.
Place the old chassis on an
ESD-safe
surface.
4.
Unpack the
new chassis
and place next to the old chassis.
Move Components to New Base Chassis
1.
Move the
power supplies
from the old chassis to the new chassis (see
2.
Move the
tape drives
from the old chassis to the new chassis (see
).
3.
Move the
library controller
from the old chassis to the new chassis (see
Install New Base Chassis in Rack
1.
Slide out the
middle
rack rails on both sides.
2.
Using the mechanical lifter, position the
new chassis
in front of the rack.
3.
Insert the chassis
inner rails
into the middle rack rails and slide the chassis into the
rack until it is flush with the front.
Power Supply
Tape Drive
Controller
