Overland Storage XchangeNOW ARCvault Series, Remove & Replace Instructions

Page: 2 / 4

Part Number 10400010-106 06/2008
©2007-2008 Overland Storage, Inc.
Page 2 of 4
b. Unscrew each shipping screw about one-half inch
leaving the screws in the well-nuts.
c. Using the finger pulls, remove and retain the well-
nuts and screws .
d. Carefully return the library to its normal, upright
operating position.
6. Opening the left door , remove and retain the screw
holding the shuttle bracket in place ( Figure 2 ).
Figure 2. Remove the Bracket Screw (Top Inside View)
7. Remove the shuttle bracket ( Figure 3 ):
a. Slightly lift the bracket up to clear the shuttle.
b. Swing the rear of the bracket to the left aligning it
with the magazine bay.
c. Pull the bracket straight out and retain.
Figure 3. Remove the Shuttle Bracket
8. Close the door .
9.
At the rear, remove the AC receptacle label ( Figure 4 ).
Figure 4. Removing the AC Receptacle Label
10. Place the packaging components in the box, including
the bracket, and set aside for returning the old unit.
To replace a chassis, you must first remove the media
magazines (
Figure 5 ).
NOTE: ARCvault 12 model only has one magazine located on
the right side.
Figure 5. ARCvault Magazines to be Removed
CAUTION: Keep a loaded magazine level. Don’t hold
magazine by the handle; use both hands to support it.
Remove Magazines with Power On
1. At the OCP Default screen, press Media > Mag
Access > OK (at the offline message) > Unlock All .
2. Open the right door and remove the right magazine .
3. For an ARCvault 24, open the left door and remove the
left magazine .
Continue with “Remove Unit from Rack.”
Remove Magazines with Power Off
Should there be a loss of power, you can still access the
magazines in models built after November 2006 by using
the Magazine Release Tool (MRT) or a 1mm (0.040 in.)
diameter wire at least 5cm (2 in.) long.
1. Open the magazine door ( Figure 6 ).
Figure 6. Manually Releasing a Magazine
2.
Slide the MRT into the slot under the handle.
Remove This Screw
Shuttle
Bracket
Front Bezel
Well-Nut
Left Door
Opening
Hole
a
b
c
Bracket Front Lip
A
RC
-0
02
7
Remove Magazines From Old Unit
ARCvault 24 (both)
ARCvault 12
(right only)
Insert
Media Magazine
Door
Tool Here
Magazine
Release Tool