Part Number 10400010-106 06/2008
©2007-2008 Overland Storage, Inc.
Page 1 of 4
This document describes how to remove and replace an
Overland XchangeNOW ARCvault 2U chassis assembly.
WARNING: To reduce the risk of electric shock or
damage to equipment, disconnect the power cord.
CAUTION:
A bracket and screws secure the robotics for
shipment and MUST be removed before operating.
IMPORTANT: If possible, document the current settings
by printing out a Full Trace Log before swapping chassis.
Unpacking
Carefully unpack and verify that you have all the parts:
•
Spare 2U chassis assembly with drives
•
Wire Tie-Down kit
•
Magazine Release Tool
•
These remove & replace instructions
A Phillips screwdriver is also needed.
Electrostatic Discharge Information
A discharge of static electricity can damage micro-circuitry
or static-sensitive devices. To help prevent Electrostatic
Discharge (ESD), observe standard ESD precautions.
) and prepare it to receive the magazines and drives from the old unit.
Figure 1. Unpacking the Spare Chassis
WARNING: Due to the weight of the unit, it is
recommended that at least two people be used to lift
the unit out of the box to prevent injury.
1.
Open the top of the box (
) and lift off the top
end caps
.
2.
Remove the
Wire Tie-Down
kit.
3.
Lift the
ARCvault
out and set it on a secure surface.
4.
Remove the
ESD bag
.
CAUTION:
Do NOT turn the chassis upside down or
allow the front bezel or door to contact the table.
5.
Remove the
shipping screws
underneath (
a.
Turn the unit onto its
left side
making sure the
front bezel does not touch the table
.
ARCvault
®
Series XchangeNOW
®
2U Chassis Assembly
Remove & Replace Instructions
Overview & Notes
A
RC
-0
01
1
Unpack Spare Chassis
AR
C-
01
71
End Cap
End Cap
Spare Chassis
ESD Bag
Carton
Tie-Down Kit
A
RC
-0
04
8
Front Bezel
Off Table
Screws & Well-Nuts
Must Be Removed
Shuttle Bracket Hole
Screw
Well-Nut
Pull
