Overland Data DLT LoaderXpress, Installation And User Manual, Page: 62 / 78

3-4 DLT LoaderXpress™
M
AINTENANCE
When you press the
)RXIV
button, the Cleaning In Progress screen displays: button to
return to the Cleaning submenu.
*MKYVI'PIERMRK-R4VSKVIWW7GVIIR
When the cleaning operation is completed, the Default Screen reappears.
6IQSZMRKXLI'PIERMRK'EVXVMHKI
1) Examine the Default Screen on the Control Panel to make sure the cleaning
cartridge has been unloaded from the drive. If not, then unload it using the
Load/Unload Menu, as described in
Chapter 3 - Operation .
2) Remove the magazine from the LoaderXpress (refer to “Inserting Cartridges
Into the Magazine” in Chapter 3).
3) Remove the cleaning cartridge from the magazine.
4) Insert any desired data cartridge into the slot vacated by the cleaning cartridge.
5) Insert the magazine into the LoaderXpress™.
6) Close the magazine door.
9WMRKXLI(IQS7YFQIRY
Use this option to fully exercise the library robotics.
1) From the Maintenance Menu, select the Demo Submenu.
2) Select Demo 1.
The library robotics begin to move cartridges randomly from slot to slot, displaying the
number of passes on the screen.
If all slots in the magazine are full, Demo 1 loads a cartridge into DLT1 and leaves it there.
If you press the
p
button while Demo 1 is running, the LoaderXpress loads a cartridge
into DLT1, unless DLT1 is full. If you press the
p
button again, the cartridge is unloaded
from DLT1 and returned to the magazine.
Demo 1 runs continuously as long as the LoaderXpress has power.
Cleaning:
Using:
Cleaning in Progress
DLT 1
Slot 1