06
Installation and configuration
Prerequisites for installation
You must have an internet connection, with an ADSL box equipped with an Ethernet port.
It will be necessary to note down the PIN for the Kizbox
®
box (this number can be found
on a label affixed to the box, and will be requested when the product is activated).
Installation
- Connect the product to your ADSL box; connect the RJ45 cable provided to the
Ethernet connector indicated by the logo .
- Connect the power supply provided to the power supply connector.
Warning
- Place the box at least 30cm away from the internet modem.
- Do not place the box on metallic surfaces or inside a metallic case.
- Do not place the box near a metallic surface and/or inside a duct containing electric cables.
- Do not use the box in areas where devices using radiofrequency transmission are prohibited (please
refer to local standards in application).
- Do not place the interface near devices which could be affected by radio waves.
- Only use the power supply supplied to connect to the mains.
- Unwind the electric cable fully before connecting it to the socket in order to avoid overheating.
- The power supply and its cable must be kept out of the reach of children and away from pets, while
remaining accessible so that it can be disconnected quickly in case of emergency.
Configuration
- Refer to the mobile application user guide for any information about device paring.
- Refer to the product’s user guide to set it in configuration mode.
Technical data
Housing
- Index protection rating IP20.
- Operating tempe0°C to 50°C.
- Maximum operating altitude: < 2000m.
- Pollution degree: 2.
- Operating humidity: between 30% and 85%.
- Dimensions (L x l x h) 151 x 142 x 60 mm.
- ABS-PC plastic housing.
- Consumption in normal conditions : continuous
5V/800mA
- Rated current of the USB extension connectors:
500ma for the upped connector and 1A for the sum
of the lower connectors.
Main adapter
- 230V ~ 50Hz power supply.
- Continuous 5V / 2A power supply.
Radio
- Radio frequencies 868.25MHz (<25mW),
868.95MHz (<25mW) and 869.85MHz (<25mW) in
compliance with the standard io-homecontrol.
- Radio frequencies 433.92MHz (<10mW) in
compliance with the standard RTS.
- Class 2 receiver.
Summary of Contents for Kizbox II
Page 1: ...Kizbox II Operating and installation...
Page 2: ...02...
