6
Programming Overview
NOTE:
Before you begin programming, check to make sure there are
no objects in the garage door opening.
INTRODUCTION
Now that your Overhead Door® garage door opener is installed, you
will want to program the opener so that the door open and closes
properly and all remote devices operated correctly. The following steps
guide you through setting your opener so it functions properly for you.
The following information will take you through programming your
opener’s functional settings for use.
OVERVIEW OF POWERHEAD CONTROLS
This section describes the programming functions on the powerhead
of the opener. Use the following information to familiarize yourself with
the buttons, LED indicators and products used to program functions.
Powerhead: There are 3 programming buttons and 2 LED lights on
the powerhead. Each of the buttons is used to enter and complete
the setup programming. The LED lights indicate status or a function
change by illuminating ON, OFF, or ON FLASHING in one of three
different colors: blue, red or purple.
There are 3 programs:
1. Door Travel Limits.
– This program is used to set how far your door travels up
and down.
2. Remote Programs (default menu)–only required for added
remote control transmitters.
–These show you how to program your remotes to sync with
additional remote control devices, wall consoles,
keypads and the powerhead.
3. Force Setting Program.
– This program controls the force applied in during the closing
and opening of your door. They are factory set and will rarely
requires adjustment only under certain circumstances.
NOTE:
The 3 programming buttons are for programming ONLY. These
buttons should NOT be used to operate the opener once the Required
Programming section has been successfully completed.
