Overhead door CodeDodger, Installation And Programming Instructions

Page: 6 / 12

WARNING
!
During programming, the door opener
could begin to run. Stay away from
moving door and its parts. To prevent
door from moving, close door using
the wall button and disconnect it from
opener by pulling Emergency Release
Cord (See owners manual).
NOTE: Programming must be completed within 30 seconds of pressing programming
button or receiver will turn off remote programming mode. Press button again to enable
programming mode and resume programming remote.
NOTE: If receiver does not perform properly, check connections between power source and
receiver and connections between receiver and operator
Programming CodeDodger® Remotes (Three Door Mode):
Note: Open/Close/Stop remotes cannot be used in this mode.
Three Door Mode is the default factory setting. If an open/close/stop remote has been
previously programmed to the receiver use the CLEAR ALL REMOTES instructions section
below to reset the receiver into Three Door Mode.
1. Press and release the door button on the receiver for the door you desire to use the
remote with. The door LED will begin flashing.
2. Press and release the remote button. The door LED will change to solid.
3. Press the remote button a second time. The door LED will turn off.
4. The next remote button press will activate the receiver.
Programming CodeDodger® Open/Close/Stop Remotes (Single Door Open/Close/Stop
Mode)
Note: Single button and fixed code remotes cannot be used in this mode.
Note that the first open/close/stop remote programmed to the receiver will change
the mode from Three Door to Single Door Open/Close/Stop mode. If remotes have
previously been programmed to the receiver in Three Door Mode, clear the receiver
memory using the CLEAR ALL REMOTES instructions section.
1. Press and release any door button on the receiver. The door LED will begin flashing.
2. Press and release any button on the open/close/stop remote. The door LED will
change to solid.
3. Press the same remote button a second time. The door LED will turn off.
4. The next remote button press will activate the receiver. All three buttons on the
remote are now programmed.
PROGRAMMING RECEIVER
AVERTISSEMENT
Durant la programmation, l’ouvre-
porte pourrait commencer à
fonctionner. Restez éloigné de la
porte en mouvement et de ses
pièces. Pour empêcher la porte de
se déplacer, fermez la porte à l’aide
du bouton mural et débranchez-la
de l’appareil en tirant sur la corde de
déverrouillage de secours (Référez-
vous au guide du propriétaire).
!