8. Install door bracket (Fig. 2-6).
•
Contact door manufacturer.
NOTE: Self-drilling screws are intended for use with light-
weight door only, while lag screws are meant for wood
doors only.
Because door designs vary, modifications may be
required and additional materials needed. Please contact
your door manufacturer with any questions concerning
your door.
9. Install door arms (Fig. 2-7).
•
Attach straight door arm to carriage.
–
slip straight door arm into slot at bottom of
carriage as shown.
–
secure with clevis pin [90] and cotter pin [89] .
•
Attach short end of curved door arm to door
bracket as shown.
–
slip short end of curved door arm into slot in
door bracket.
–
secure with clevis pin and cotter pin.
•
Release carriage (See emergency release tag).
–
slide carriage towards closed door.
–
stop carriage 14
”
minimum from door.
10. Join door arm sections (Fig. 2-8).
•
Use two (2) 3/8
”
x 7/8
”
hex bolts [91], and hex
flange nuts [92].
–
use any two holes as far apart as possible.
–
slide carriage back and forth as needed to
align holes.
•
Tighten hex nuts securely.
11. Adjust emergency release cord length.
•
Mount the emergency release knob 6 feet from
the floor.
•
Retie overhand knot and trim excess cord.
DO NOT plug power cord into outlet.
Go to Section 3-SAFE-T-BEAM
®
SYSTEM INSTALLATION.
– PROCEED TO PAGE 18 –
Fig. 2-8
Straight door arm
Curved door arm
Fig. 2-6
Fig. 2-7
14
”
MIN.
Straight door arm
Curved door arm
Top of Door
Dessus de la porte
Top of Door
Dessus de la porte
“
V
”
“
V
”
“
V
”
“
V
”
“
V
”
Top of Door
Sectional doors
One-piece doors
“
V
”
14
OR
1/4
”
x 2
”
Lag Screw
1/4
”
-20 x 3/4
”
Self-Drilling Screw
OPEN YELLOW PARTS BAG
Top of Door
Clevis pin
[90]
Cotter pin
[89]
[96]
[79]
[79]
[79]
[79]
[96]
[96]
[96]
[90]
Clevis pin
[89]
Clevis pin
[91]
[92]
Bolt, 3/8
”
-16 x 7/8
”
Nut, 3/8-16
[92]
[91]
3/8-16 nut
Bolt,
3/8-16 x 7/8”