R-Tronic quick start guide
Pairing Thermostat and Operator
Turn the knob to show the
MAINMENU
and push the knob to enter.
Turn the knob clockwise until the
display shows
SETTINGS
and
push the knob TWICE to enter
the
TEACH
function.
Push the knob once to start the
TEACH
function. The TEACH
function will remain active for 30
seconds.
While the TEACH function is active,
push the LEARN button on the
operator once.
1
2
3
4
The operators MUST be within 2
feet of the thermostat for pairing
to be successful.
Repeat steps 3 through 5 for
each additional operator.
When the operator has been paired
with the thermostat the operator’s
LEDs will flash three times.
5
LEDs
Learn button
Mounting Operator to Valve
Thread the operator to the valve’s
actuator connection.
Push and hold the LEARN button
to start the operator’s calibration
cycle. Release button once motor
starts to move.
When the operator has finished
its calibration cycle the LEDs will
flash green three times.
1
2
3
Do not use tools to mount the
operator to the valve. Hand
tighten only.
Recalibration is not necessary
when the batteries are replaced.
When finished mounting the
operator to the valve, reattach the
operator cover.
4
If actuator blinks red,
recalibration is required.
Oventrop Corporation · Phone 860.413.9173 · www.oventrop-us.com
