p. 6
INSTALLATION INSTRUCTIONS
Uninstall the 2 caps and 2 screws from the toilet seat.
4
Flip the seat cover gently and rest it onto the toilet bowl. Take care of not
pulling the connected wires.
The seat cover has a clip, holding it in place on the ceramic base. To
release the seat cover, firmly push the 2 plastic side panels near the top
with your fingers and pull up the seat cover.
5
6
PUSH
Position correctly the two fixing bolts of the floor flange.
3
Install the floor flange according to the manufacturer’s
recommendations. Ensure that the flange is flush with the floor.
If the flange is not flush with the floor, this may result in an
inadequate installation.
Ensure that your water inlet pipe and your floor discharge drain are
installed according to the drawing. These are minimum measurements,
the toilet can be installed if your actual measurements are longer than
shown.
TIP: Align 2 pieces of masking tape with the center of the drain,
this will help you position the toilet in future steps.
1
2
150mm
400mm
305mm
NOT
SUPPLIED
Summary of Contents for GODFREY
Page 18: ...p 18 INSTALLATION PICTURE...