READ FOLLOWING INSTRUCTIONS AND WARNINGS BEFORE USE
IMPORTANT
• Power supply must be 230 volt AC (240 volt for UK plug) or automobile cigarette lighter 12
volt DC.
• This pump is intended to inflate/deflate items, such as inflatable boat, air mattress, etc. it is
not designed for continuous use.
• Extended operation over 25 minutes can overheat and damage the pump.
• Keep the air pump out of reach of children.
• Do not obstruct the inflation/deflation port and keep them ventilated at all times.
• For fast inflation and shorten the motor’s working time, always use the suitable adapter
according to the size of valve of the inflatable item.
WARNING
• To reduce the risk, contact qualified electrician to repair or replace a damaged cord
immediately.
• Carefully following the instructions on inflatable items when inflating. Never exceed
recommended pressure; otherwise, serious injury might be caused by the bursting item.
• Never leave the pump unattended while in use.
• Do not keep/use the pump in wet condition.
• Never allow sand, small rocks, etc. to be sucked into inflation/deflation port when using the
pump.
• Never look inside or point the inflation/deflation port toward your eyes when the pump is
running.
• Never attempt to put your hand or fingers into the inflation/deflation port at any time.
• Do not use the pump as hair drier. Avoid getting your hand to close to the area of inflation
port while in use. Doing so might lead to injuries.
SKY PUMP
Inflation port
Deflation port
Connector
Deflation vent
Adapter
Output plug
Transformer
Transformer - UK
Cigarette plug
Switch
2
3
TO INFLATE ITEMS
• Insert output plug to the socket of the pump. Then connect the transformer to 230 volt AC
circuit (240 volt for UK plug), or connect cigarette plug to automobile cigarette lighter 12
volt DC.
• Connect the adapter to the inflation port through the connector. Hold the pump against
the valve of the inflatable item and switch on the inflation / switch off for stop. (the symbol
“-“ on the switch means ON and the “o” means OFF)
• The valve of the inflatable item should not be obstructed otherwise it can overheat and
damage the pump.
• Never use the deflation vent when inflating the item. On large items like an inflatable boat,
king size air beds etc., the pump should fit directly to the valve of the inflatable item for fast
inflation. Use the appropriate adapter for smaller valves.
TO DEFLATE ITEMS
• Open the valve on the inflatable item.
• Connect the adapter to the deflation port through the deflation vent. Insert it in the valve
and switch on for deflation / switch off for stop. (the symbol “-“ on the switch means ON
and the “o” means OFF)
• The valve of the inflatable item should not be obstructed otherwise it can overheat and
damage the pump.
• For small valves on an inflatable item you may have to pinch with your finger to open the
flapper of the valve and allow the air to escape.
• For quickly inflating the item with screw valve, unscrew the safe bolt and inflate directly
with the pump. When finished screw the safe bolt on, remove the top of the safe bolt for
fully inflating the item. For deflation, unscrew the safe bolt to deflate directly.
Summary of Contents for Sky Pump
Page 1: ......
