Architectural Products by Outwater assumes no liability for improper installation.
Page 5
5. Using the supplied 1 1/4” washer-head screws , secure the step to the side rail through the pre-drilled holes
on the side rails (for aesthetic purposes, don’t over tighten the screws which can crack the wood around
the screw head). Assemble the remaining steps in the same manner
(figure 9)
.
6. Once all the steps are assembled onto one of the side rails, position the side rail on its side with the steps
pointing up.
FIGURE 9
FIGURE 10
FIGURE 11
FIGURE 12
FIGURE 13
7. Apply a thin film of glue on the ends of each step and in the dado of the other rail.
8. Properly align each step in the dado with the mark on the surface of the step
(figure 10)
. Use the supplied
1 1/4” washer-head screws to complete the fastening of the steps into the side rails
(figure 11)
.
9. Installation of the step support rods:
•
Thread the support rod into one of the nut caps, leave half of the thread on the rod showing.
•
Slide the support rod through each hole in the ladder side rails, install the other nut cap.
•
Using two 5mm Allen wrenches, tighten each side simultaneously so that there are equal amounts of
thread on each side of the rod
(figures 12 & 13)
.
Summary of Contents for architectural products E-GLIDE EG.300 Series
Page 12: ...REV 08 13 20 ...
