Outsunny YP-2000B Quick Start Manual Download Page 7

Page: 7 / 7

■

Before installing your appliance, you must disconnect the electrical

supply at the circuit breaker.

■

Use the four screws to fix the bracket of the heater on the wall on a right

position and then fix the heater on the bracket.

5-OPERATION

The appliance is switched on by means of the pull switch . The slight vibration

noticeable when the appliance is switched on will stop after a few seconds.

6-OUTPUT

-Position 0: Stop

-Position 1: 650W (normal power)

-Position 2: 1300W (intermediate power)

-Position 3: 2000W (full power)

7-MAINTENANCE

Your appliance dose not requires any particular maintenance. However, in

the event of a malfunction,

please consult an Approved Service Center

Summary of Contents for YP-2000B

Page 4: ... 4 5mm of screws higher than metope As shown below E Hold up the product to make the back of the product wall mounted holes into the four corresponding screws which are Exposed on the wall Move the product to the left into the safe holes on the wall hanging part of product As shown below ...

Page 5: ...tention during installation the distance between the top of the product and ceiling should be more than 0 5m the distance between the side of the product and corner should be more than 0 5m the distance between the bottom of the product and floor should be more than 2m In summary To ensure safe use of the product As shown below ...

Page 6: ...H For the safe use of the product please install the product in correct installation method never install the product inversely on the wall or be fixed on the ceiling As shown below ...