Outsunny B30-006 Instructions Download Page 4

BATTERY REPLACEMENT

Step 1: Detach light cover from the top of the lens section by twisting it in an anti-clockwise

direction and gently lifting off.

Step 2: Lift off the battery lid and replace old battery with new rechargeable 3.7V 14500 Lithium-ion

battery.

IMPORTANT : When the battery life is exhausted, the battery must be recycled or disposed of

properly.

DO NOT DISPOSE OF BATTERY IN FIRE

Step 3: Replace battery lid, and replace light cover back onto the lens section.

TROUBLESHOOTING

If your solar light does not automatically turn on at night, it may be caused by one of the following

conditions:

1. H/L/OFF switch is not in H/L position. Slide the switch to H/L position.

2. Battery is not fully charged or needs replacing

3. Battery may not have been installed correctly. Check to ensure that the battery is not loose and

has been installed the correct way

4. Solar light might be positioned in a shaded location, limiting its exposure to the sun and not

allowing the battery to fully charge

5. Solar light might be too close to another night time light source, including another solar light.

6. Solar panel may be dirty, limiting its exposure to the sun and not allowing the battery to fully

charge. Clean the top surface of the solar panel regularly with a dampened cloth or paper towel

If your solar light only lights up for a few hours in stand-by mode, the solar panel may not be

receiving enough sunlight to fully charge the battery

NB : The performance of your Solar Light is dependent

on your geographical location, weather conditions and

seasonal lighting availability. On cloudy days and during

winter, the solar charge panel will not receive as much

direct sunlight resulting in reduced brightness and reduced

operating time

Summary of Contents for B30-006

Page 1: ... to 30 lumens and up to 8 hours working time POSITIONING YOUR SOLAR LIGHT Your solar light includes a built in photo sensor which detects the level of surrounding natural light and controls when the light will automatically switch on and off Solar light should be placed away from other night time light sources including other solar lights as this might keep the light from automatically turning on ...

Page 2: ...r light head A 1 x pole piece with female thread B 2 x pole pieces with female male thread C 1 x pole piece with male thread D 1 x mounting base E 1 x ground stake F 3 x mounting screws G 3 x plastic anchors H ...

Page 3: ...ounting base over the centre of the installed ground stake Step 4 To complete installation re attach the assembled solar light into the opening at the top of the mounting base HARD SURFACE INSTALLATION Step 1 Remove mounting base from the bottom of the assembled pole and gently place light down Step 2 Using a pencil place marks through the 3 holes located around the edge of the mounting base Step ...

Page 4: ...orrectly Check to ensure that the battery is not loose and has been installed the correct way 4 Solar light might be positioned in a shaded location limiting its exposure to the sun and not allowing the battery to fully charge 5 Solar light might be too close to another night time light source including another solar light 6 Solar panel may be dirty limiting its exposure to the sun and not allowin...

Reviews: