Step 1:
Assemble lens section and cover together, by aligning the locking tabs on the side of the lens
section with the slots on the underside of the light head, and twist over in a clockwise direction to
lock it into place.
Step 2
: Assemble the poles with threaded ends. Secure the pole pieces by twisting the threaded ends
together.
Step 3:
Insert the assembled pole into the opening at the top of the mounting base.
Step 4:
Attach assembled light head over the top of the assembled pole to complete installation
FIRST TIME USE
Step 1 : Slide the H/L/OFF switch to the H/L position.
Step 2 : Your solar light will then automatically switch on at dusk and charge during daylight hours.
INSTALLATION
This light can be installed in soft ground or into a hard surface
SOFT GROUND INSTALLATION
Step 1: Locate an area where you wish to place the light and insert stake into the ground. Insert stake
leaving approximately 10cm length above the ground’s surface. If the ground is hard, soften by
soaking area with water first or gently tap the stake into the ground using a rubber mallet.
Step 2: Remove mounting base from the bottom of the assemble pole and gently place light down.
Step 3: Attach mounting base over the centre of the installed ground stake.
Step 4: To complete installation, re-attach the assembled solar light into the opening at the top of the
mounting base.
HARD SURFACE INSTALLATION
Step 1: Remove mounting base from the bottom of the assembled pole and gently place light down.
Step 2: Using a pencil place marks through the 3 holes located around the edge of the mounting base.
Step 3: Remove the base from position and drill a hole at the 3 points marked, large enough to fit the
plastic anchors inside.
NB: Before drilling holes, it is recommended that you first check the light effect at night to
ensure you are happy with the position yo have chosen for installation. Be sure to also check
that the location will receive direct sunlight each day to charge the battery.
Step 4: Place plastic anchors into each hole.
Step 5: Re-position the mounting base onto the surface, aligning the holes with the plastic anchors.
Step 6: Using a screwdriver, insert screws through the 3 holes on the mounting base and into the
plastic anchors. Tighten screws to secure the mounting base onto the surface.
Step 7: To complete installation, re-attach the assembled solar light into the opening at the top of the
mounting base.
NB: If mounting onto a timber surface, plastic anchors are not required. Simply drill the
screws directly into the surface through the holes on the mounting base
