En-10
1-888-514-1663 |
WWW.OUTLANDLIVING.COM
NOTE TO USER:
Before igniting the unit for the first time, follow steps one through 5 in the below Ignition section.
STEP 3
Ensure the gas hose is not contacting the top of the Fire Table
enclosure and the tank is stabilized in the collar with the wing nut.
Caution: Always ensure the gas valve
orifice and burner tube venturi is clear of
all debris including spider webs.
STEP 2
Connect the LP gas cylinder. See section labelled ‘Connection’.
SECTION 2:
IGNITION
STEP 1
Ensure that the gas valve knob is in
the “OFF” position by pushing and
turning clockwise until the dial stops.
STEP 5
Leak Test all connections. See section labeled “Leak Test”.
STEP 4
***SLOWLY***
turn cylinder valve to the open position to avoid
tripping the CSA excess flow safety device in the gas regulator.
For more information about the CSA excess flow safety device see
Section 3 (page 12).
STEP 6
Your Fire Table is equipped with an auto spark ignition (piezo
ignition). Push the knob in and slowly turn counter-clockwise to the
high position. The ignitor will spark and ignite the gas.
Should the appliance fail to ignite on the first try, promptly repeat
the ignition attempt within 5 seconds. If a third attempt fails to ignite
the Fire Table then rotate the knob to the “off” position and wait 5
minutes before attempting to ignite again.
WARNING:
Ensure that no parts of your body, clothing, or any
other combustible material are above the burner before, during
and after ignition.
Ensure the cover is stored safely away from
the Fire Table when the Fire Table is in use.
