T H E O U T D O O R P L U S . C O M
2 3 5 E A S T M A I N S T
9 0 9 .4 6 0 . 5 5 7 9
P A G E 8
INSTALLATION
STEP 6
Install ½” gas hose to your gas riser (or manual gas
shutoff valve) so that the end of the ½” gas line is 1”
SHORTER than the pole (measurement “B” from the
previous page)
In addition, bring the wires previously installed
up along the gas line and tape it to the gas line in
anticipation of installing the longer tiki pole.
STEP 7
As shown in diagram 6, Measure from
the bottom of the long tiki pole up to
measurement “A” and mark the pole. Then
drill a 1” diameter hole in the side of the pole
for the Manual Gas Shutoff Valve.
STEP 9
In diagram 8, you are looking at a close up of the
bottom of the Tiki Torch Head. Unless a custom
configuration is requested there will be the 2 wires as
shown along with a ½” coupling.
STEP 9
Next install the Manual Gas Shutoff Valve as shown in diagram 7.
A
A
DIAGRAM 6
DIAGRAM 7
DIAGRAM 8
TOP TORCH
