8
Igniter Installation
1.
Make sure the valve is in the OFF
position before beginning.
2.
Install sparker as shown, using an
AAA battery (not included).
Sparker will not operate correctly without an ignition
and
ground wire attached.
3.
Plug both
BLACK
wires hanging from the burner into the
back of the sparker box.
4.
Test system by pushing the button on the igniter.
Consult the troubleshooting section if spark is weak,
intermittent, or not present.
After installing igniter and making gas connections,
verify that they are tight and that no leaks are present
using a solution of soapy water or a commercially available
leak-check solution.
