Proper care and appliance maintenance will keep your product operating smoothly.
CLEAN THOROUGHLY AFTER EVERY USE.
HOW TO CLEAN:
1. Before cleaning turn off the boiler at the regulator/ manual valve then at the gas cylinder. Check that
there is no flame, gas smell and the valves are in off position. Next , make sure unit is properly
disconnected from propane tank prior to any cleaning.
2. Before removing the water, let the unit completely cooled down. As a precaution use protective heat
resistant gloves.
3. Everything that was in contact with the food must be hand washed with warm soapy water and nylon
pad. If the pots have black soot cooked on to the outside finish, scrub this down with a steel wool scouring
pad. DO NOT spray oven cleaner on aluminum pots to remove grease or soot. It will cause the finish to
become dull. If food remains stuck to the aluminum basket add hot water and let it soak, after cooling,
scrub with steel wool.
If hard water causes darkening on the interior of the pots, fill to the level of the
darkened area with a water and cream of tartar or vinegar solution
（
mixed concentration of three cups of
water to one tablespoon cream of tartar or vinegar). Boil five to ten minutes.
4. To Clean to the Burner, use brush to loosen corrosion from burner exterior. Clean clogged gas port holes
with an open paper clip. Replace corroded or damaged burners that would emit excess gas. (see next page
for more detail)
5. Confirm that all components are completely dry before using or placing in storage.
6. Store all components in a dry, covered location when not in use with the cylinder detached.
NOTE:
Clean the entire appliance each year and tighten all hardware on a regular basis (1-2 times a year
or more depending on amount of use).
CAUTION
Allow unit to fully cool before performing any cleaning.
SUGGESTED CLEANING MATERIALS:
•
Warm water
•
Mild dishwashing liquid detergent
•
Soft, nylon cleaning pad
•
Paper Clip
Steps for Cleaning the Burner
1. Remove brass connector / hose from the burner.
2. Look inside the burner tube for nests, webs, or mud.
3. To remove the above obstructions, use an a
FLEXIBLE
accessories, brush, or bend a small hook
on one end of a long flexible wire. (as shown in figure
2)
4. Inspect and clean the burner if needed.
5. Reattach brass connector to burner.
Care and Maintenance
Page 20 of 21
Summary of Contents for 156633
Page 9: ......