Items needed:
Items needed:
1 - Fish Cat Scout
1 - Foot bar
1 - Fish Cat Scout
with foot bar
1 - Inflation pump
1 - Vinyl tube valve adapter
1 - Summit 2 valve adapter
1. The foot bar needs to be installed with the boat deflated.
2. Choose the best position for the foot bar depending on your size.
3. Slide the foot bar through both PVC loops.
4. Repeat on the other side.
5. NOTE: Inflating the boat will lock the foot bar into place.
Step 1: Foot Bar Installation
Step 2: Inflation
1. Remove the dust caps from the valves
2. Push and turn the valve stem 1/4 turn. This positions the valve stem in the up or
closed
position. Having the valve stem in the
closed
position allows air to be pumped into the Fish
Cat Scout and will prevent air from escaping out.
3. Connect the vinyl tube adapter to the pump hose.
4. Connect the Summit 2 valve adapter to the vinyl tube.
5. Insert the Summit 2 valve adapter into the valve and turn it to lock it into place.
6. Inflate the Fish Cat Scout collar and floor to soft pressure.
7. Inflate the Fish Cat Scout collar and floor to full pressure, about 2.5 psi. A good rule for
estimating the proper pressure is to push with your thumb at the center of the tube, when
you can depress about 1/4” from the top surface of the tube, it will be close to 2.5 psi.
8. Place dust caps on the valves.
Changes in air temperature and elevation could cause the air inside the Fish Cat Scout
to expand which could cause damage to the AIREcells.
Never leave your fully inflated tube sitting in direct sun light out of the water.
Always release some air when these conditions occur.