background image

18 

or regulator.

 

 

Insert  lit  match  through  the  right  match-

lighting  hole  on  the  right  side  of  the 

barbecue  body  and  place  near  rightmost 

burner porthole. 

 

Push  and  turn  the  rightmost  control  knob 

anti-clockwise  to  the  high  position,  taking 

care to protect yourself from the flames. 

 

When  the  right  burner  is  lit,  turn  the 

remaining burners on from right to left. 

 

Confirm  that  each  burner  is  alight  before 

turning on the next burner. 

 

To light the side burner, place the lit end of a 

long match alongside the side burner. Push 

and turn the side burner knob anti-clockwise 

to  the  high  position,  taking  care  to  protect 

yourself from the flames.  

 

If  a  burner  fails  to  ignite,  contact  your  local 

dealer for assistance. 

 

After  ignition,  turn  the  burners  to  the  high 

position for 3-5 minutes in order to pre-heat 

the  barbecue.  This  should  be  done  before 

each  cooking  session.  The  hood  or  lid 

should be open during preheating.  

 

After  completion  of  preheating,  turn  all 

burners  to  the  low  position  for  best  cooking 

results. 

 

Grill Cooking 

The  burners  heat  up  the  flame  tamers 

underneath  the  grill,  which  in  turn  heats  the 

food  on  the  grill.  The  natural  food  juices 

produced  during  cooking  fall  onto  the  flame 

tamers  below  and  vaporise.  The  subsequent 

rising  smoke  bastes  the  food,  as  it  travels 

upwards,  imparting  that  unique  barbecued 

flavour.  

 

Griddle Plate Cooking (Where applicable)

 

The  burners  heat  the  griddle  plate  directly, 

which  then  cooks  the  food  on  contact.  Griddle 

plates  allow  for  the  cooking  of  smaller  items, 

such  as  seafood,  which  could  fall  through  the 

spaces  of  a  grill.  They  are  also  suitable  for 

cooking  items  that  require  high-temperature/

short-duration cooking, such as vegetables and 

smaller cuts of fish. Similarly, it can be used in 

exactly  the  same  way  as  a  griddle  in  the 

kitchen,  for  searing  steaks,  cooking  eggs,  etc. 

Alternatively, it can be used for heating pans or 

keeping food warm. 

 

Roasting Hood Cooking 

Barbecues  equipped  with  a  roasting  hood  give 

the  option  to  form  an  ‗oven‘  for  roasting  or 

baking  food,  such  as  joints  of  meat  or  whole 

chickens,  etc.  More  even  cooking  of  food  will 

actually be achieved by using the barbecue with 

the hood down. 

However, this should only be 

done with the burners on low.   

 

For  best  results,  place  the  food  you  wish  to 

bake or roast on a metal baking tray and set it 

on one side of the cooking grill. 

 

Turn  the  burner  directly  under  the  food  to  the 

OFF  position  and  turn  all  other  burners  to  a 

LOW to MEDIUM position. 

 

Close  the  hood  to  cook  the  food  ‗indirectly‘. 

Avoid  lifting  the  hood  unnecessarily  as  heat  is 

lost every time the hood is opened. If the hood 

is  opened  during  cooking  please  allow  extra  

time for the barbecue to regain its temperature 

and complete the cooking. Use the temperature 

gauge to monitor the heat of the barbecue. 

 

If  the  internal  heat  becomes  too  high,  turn  the 

burners  down  to  the  low  position.  It  is  not 

necessary  or  advisable  to  have  all  of  the 

burners on high when the hood is closed. 

 

DO  NOT  ALLOW  YOUR  BARBECUE  TO 

OVERHEAT.  Be  careful  of  hot  steam  when 

opening the hood. 

 

Warming Rack 

 

Warming  racks  are  a  convenient  way  to  keep 

cooked  food  warm  or  to  warm  items  such  as 

bread  rolls.  It  is  advisable  to  place  food 

(particularly  fatty  foods)  to  the  front  of  the 

warming  rack  to  avoid  the  possibility  of  juices 

and  fat  running  down  the  back  of  your 

barbecue. Always check that your warming rack 

is properly fitted before use. 

 

Flare-Up Control *Very Important Notice*           

Flare-ups  occur  when  meat  is  barbecued,  and 

its fat and juices fall upon the hot flame tamers. 

Smoke of course helps give food its barbecued 

flavour, but it is best to avoid excessive flare-up 

to  prevent  food  being  burned.  To  control  flare-

ups,  it  is 

ABSOLUTELY  ESSENTIAL 

to  trim 

away  excess  fat  from  meat  and  poultry  before 

grilling,  use  cooking  sauces  and  marinades 

sparingly  and  try  to  avoid  very  cheap  cuts  of 

meat or meat products as these tend to have a 

high  fat  and  water  content.  Also,  the  burners 

should  always  be  placed  on  the  low  setting 

during cooking.  

 

When  flare-ups  do  occur,  they  can  usually  be 

extinguished  by  applying  baking  soda  or  salt 

directly  onto  the  flame  tamers.  Always  protect 

your  hands  when  handling  anything  near  the 

cooking surface of the barbecue and  take care 

to protect yourself from the flames.  

 

If  a  fat  fire  occurs,  please  see  the  instructions 

Summary of Contents for Jupiter RS4491H
























Reviews: