OutBack Power Alino TL Series, Owner'S Manual

Page: 31 / 48

900-0248-01-00 Rev A
31
Settings
General Settings
Figure 25 General Setting Items
To enter the Setting screen mode, press and hold button
6
for up to 3 seconds. In this mode,
buttons
4
and
5
proceed up and down through the following table. Pressing
6
a second time
allows the selected item to be set with
4
and
5
.
To exit a selected item, press
6
again. To exit the Setting mode, press the Escape button
1
.
The
Setting
mode is displayed in items
7
,
8
, and
9
.
7
displays the numbered program item.
9
(and sometimes
8
) displays the selection.
The Item column below also shows the default selection.
Table 5 General Settings
Item Description
0 0
E S C
Exit the Setting screen mode.
0 1
U S b
Output Source Priority setting. If multiple power sources are available, this controls which source is used
first to power the loads. This item can be set to change depending on time of day. (See page 36.)
Selections:
U S b , S U b , S b U .

U S b (utility, solar, battery): Utility power is used first. PV and battery provide power only when utility
is not available.

S U b (solar, utility, battery): PV (solar) power is used first. If it is not enough, utility power assists PV.
Batteries will be used if neither PV nor grid is available.

S b U (solar, battery, utility): PV (solar) power is used first. If it is not enough, battery power assists
PV. Utility is only used if the battery drops to the low battery warning voltage (see page 43), or if
battery voltage drops to the grid transfer voltage in item
1 2 . It will return to using PV or battery once
the battery transfer setting (item 1 3 ) is reached.
0 2
6 0
Maximum charging current (total for PV + utility sources). Selections: 10 to 80 Adc.
1
2
3
4
5
6
7
8
9