INSTALLATION GUIDE
Product code
VF01-0001
Amka Parallel groove clamps Al/Al 16-50
VF01-0002
Amka Parallel groove clamps Al/Al 16-120
VF01-0003
Amka Parallel groove clamps Al/Al 16-120 with springs
Type
Screw head
SW
Tightening torque
M
16-50 mm²
16-120 mm²
Ouneva Oy
Teollisuustie 21
FI-82730 Tuupovaara
Tel. +358 400 179 750
Finland
13 mm
22 Nm
22 Nm
Connection
Product data
Product name
Installation
Screw mounting
- Set the connection into housing and press the
cover into its place
- Housing should not be installed upside down due
condense water
- Connection is pre-treated with oxidation
preventing grease
- Set the cables in the connector
- Tighten the screws with torque
M
- Support connector during tightening
- Remove oxidation from the connection surface
of cable with wire brush
M = 22 Nm
- Lift the cover and cut the inlet that matches the
outside diameter of the cable
