6
OPERATION
Downlead Cables
Most models of the NoizeBarrier TAC Headset have hard-wired downlead cables ready to
attach to your push-to-talk cable.
However, Models V4-10995FD and V4-11042FD have connectors for the downlead ca
-
bles to allow you to remove cables when not in use. To attach a downlead cable to these
models, simply line up the cable with the connector on the headset and push to lock it in
place. To release, pull down on the collar on the cable to easily pull the cable away from
the connector.
Install the Batteries to Power the Talk-Through Functionality
(Figure 3-6)
The OTTO NoizeBarrier TAC headset uses battery or radio power to
operate the situational awareness/talk-through functions. Batter
-
ies are not required for radio communication.
1. Identify the rubberized battery covers on the ear cups.
2. With finger pressure, pry off the battery cover on one ear cup
(Figure 3).
3. Install a AAA battery, aligning the
‘+’
and
‘-‘
symbols on the
battery with the markings in the battery compartment.
4. To close the battery cover, start by inserting one end of the
cover into the battery compartment
(Figure 4).
5.
Slightly bend the cover and insert the other end into the
opposite end of the compartment
(Figure 5).
6. Press the battery cover securely into place over the chamber
by applying pressure from the middle and moving outward
to the ends
(Figure 6)
.
7. Repeat the operation with the other ear cup.
8. When replacing batteries, be sure headset is off before
opening battery compartment.
(See instructions on page 9).
Figure 3
Figure 4
Figure 6
Figure 5
