Otto 1028763, Installation Instruction

Page: 35 / 64

- 35 -
1. Press the “power” switch: the switch turns the hood “on” & “off”.
2. Press and hold the switch “speed” to run the motor on low / medium / high / low / medium...; the speed is
circular and the LED display shows the numbers 1-2-3-1-2 in a circle.
3. Press the switch “lamp”: the light will turn on. Press the switch anew and the light will turn off. When holding
the switch, the light will alternately turn on and off.
4. When the cooker hood is operating and the “timer” switch is pressed, the hood will switch to transition mode
(transition time: 9 min.) and the LED display will show “9-8-7…-1-0”. The device will automatically turn off
upon reaching “0”. When pressing and holding the “timer” switch, the hood will alternately turn the timer
function on and off.
Operating your cooker hood
Care and maintenance
Touch control with LED display
Cleaning
Danger!
Pull the plug before cleaning the cooker hood. If it cannot be easily accessed,
turn off the power at the main fuse.
Grease deposits in the cooker hood can ignite when exposed to severe heat.
That is why it is important to regularly clean the surface of the cooker hood on
the inside and outside.
Wipe surfaces with a soft, damp cloth and some dishwashing detergent.
The glass can be cleaned with a regular window cleaner. Do not use sharp
objects or scouring powder because the surface will scratch
Cleaning/replacing the grease filter
Danger!
Grease deposits in the cooker hood can ignite when exposed to severe heat.
That is why it is important to regularly clean/replace the grease filter.
• Clean the metal grease filter once a month – more frequently if necessary –
in the dishwasher (up to 65°C) or by soaking it in warm soapy water.
• Re-insert the grease filter only after it has dried completely.
• Handle the grease filter carefully so that the fine mesh does not bend.
1. Press the “power” switch: the switch turns the hood “on” & “off”.
2. Press the button “Speed” time after time, the motor runs as low / mid / high / low / mid…, the speed runs
circularly; and the LED display will indicate as 1-2-3-1-2… circularly.
3. Press “Light” button, the light is on, press this button again, the light is off.
4. When the hood is working, if press the “Timer” button, the hood will go into the status of acquiescent working
(acquiescent time is 9mins), and then, LED display will be shown 9.8.7.6 ...decreasing by 1,when time is up,
the hood will be off automatically and the lamp will extinguish. If pressing “Timer” button, the hood will go in or
go out “Timer” function.