Otto Office OX10, Operating Instructions Manual

Page: 10 / 27

10
07/2011
english
Switch off the shredder and pull out the mains
plug. When cleaning only use a soft cloth and
a mild soap-water solution. However, no water
must enter the equipment.
After 15 to 30 min of operation, spray spe-
cial cleaning oil for shredders (order no.
1.235.997.421) through the feed opening over
the entire width of the cutting unit. Let the cut-
ting device run backwards several times in the
"REV" setting without feeding in any paper.
This loosens paper dust and particles.
7 Cleaning and maintenance 8 Disposal / Recycling
Electrical and electronic old devices
contain a variety of valuable materi-
als, but also hazardous substances
which were required for function and
safety. Incorrect disposal or handling
can be dangerous to your health and
the environment. Never dispose of old devices
in the household waste. Observe the current
applicable regulations and use the collection
points for returning and recycling electric and
electronic devices. Dispose of all the packaging
materials also in an environmentally-responsi-
ble way.
9 Technical data
Cutting type Cross cut
Shred size ( mm) 4 x 35 mm
Sa fe ty ra ting German DIN 32757 – 1 3
Cutting ca pa ci ty DIN A4 80 g/m
2
10 sheet / 1 CD, DVD
Lo ading width 224 mm
Cutting speed 30 mm/s
Voltage 230 V / 50 Hz
Power 230 W
Dimensions W x D x H (mm) 366 x 235 x 445
Weight 5.3 kg
Volume of shred. mat. container 21 l
Noise level (Idle running) 58 dB(A)
EC Declaration of Conformity
HSM GmbH + Co. KG , Austraße 1-9, D-88699 Frickingen hereby declares that the machine
document shredder OTTO Of fi ce OX10
corresponds to the health and safety requirements of the following EC directives listed below due to its conception and
design of the version in which it was put into circulation by us:
Low voltage directive 2006 / 95 / EEC
EMC directive 2004 / 108 / EC
Frickingen, 01.07.2011
Rolf
Gasteier - Technical Director