80
7.3.2 Adjusting the integrated head support
To adjust the width in the head area, up to three pads (see fig. 81, item 1) with a thickness of
10 mm
each can be
attached on each side. The pads are included in the scope of delivery for the covers. The backing film has to be
pulled off before the pads can be affixed.
1) Open the zip on the top of the padding (see fig. 8) and remove the back support pad from the integrated head
support.
2) Attach up to three pads on each side of the head support (see fig. 81, item 1, see fig. 82, item 1).
3) Reattach the back support pad and fasten it.
81
82
7.3.3 Adjusting the individually adjustable head support
CAUTION
Incorrect settings
Hitting components due to violent head movements of the user
►
Do not position yourself behind the head support during adjustment, but at its side.
INFORMATION
Observe the following when adjusting the head support:
►
Position the back of the user's head as close as possible to the contact surface of the head support (maxim
um distance: 50 mm).
►
Adjust the centre of the contact surface to the height of the top of the ears.
INFORMATION
To mount the head support: see page 10
7.3.3.1 Adjusting the angle of inclination
1) Loosen the Allen head screws (see fig. 83, no. 1).
2) Adjust the angle of inclination.
3) Tighten the Allen head screws to
5 Nm
(see fig. 83, no. 1).
33
Kimba
Settings
