6) Install the protective cap on the caster head (see fig. 21, item 1).
→
After repositioning the spacer washers, check the horizontal position of the frame with a spirit level. Readjust if
necessary.
21
22
7.8.2 Changing the installation position of the caster wheels
INFORMATION
Once changed, the left and right caster wheels must have the same vertical position in the caster fork.
The seat height/seat inclination can be subsequently adjusted by repositioning the caster wheels in the caster forks
or using different wheel sizes.
1) Loosen the screw connection (see fig. 23, item 1).
2) Remove the screw/threaded sleeve, spacers and, if applicable, nuts (see fig. 24).
3) Remove the caster wheel.
4) Insert the screw/threaded sleeve, if applicable with a spacer bushing, into the appropriate bore hole.
5) Install the caster wheel.
6) If applicable, slide on a second spacer bushing.
7) Tighten the screw/nut with a tightening torque of
8 Nm
.
→
After adjusting the front seat height, check the caster journal angle. Readjust if necessary.
23
24
21
Dino 3
Settings
Summary of Contents for Dino 3
Page 1: ...Dino 3 Instructions for use qualified personnel 3...
Page 2: ...2 Dino 3...
Page 29: ...Thread diameter M8 25 Nm 29 Dino 3 Appendices...
Page 30: ...Dino 3 30...
