5
b) Preparing for brake handle installation:
In order to mount the brake handle, you first have to make room for the installation on the push
handle tube. Proceed as follows:
Use a knife to carefully cut open the rubber grip, and then remove it from the push handle tube
(Figure 0). Remove all adhesive and material residue. A solvent may be used for this purpose.
Please observe any warnings provided by the manufacturer.
Open the superglue package. Observe the instructions provided by the glue manufacturer.
Use a spatula to apply adhesive all around the inside of the rubber grip, as deep as possible
(Figure 0). Push the grip onto the push handle tube so that 5 mm remains between the grip
and the bend in the tube (Figure 0). Allow the adhesive to cure fully.
0
0
0
