Otto Bock 743A250, Instructions For Use Manual

Page: 7 / 56

2 Product description
743A250 Bionic Pro product overview
2
The Bionic Pro consists of the following main components:
: Base station with mains plugs : iPad with mains plugs
: Sensors : Pelvic belt with two extensions
: Thigh belt with one extension : Calf belt with one extension
: Two foot clips : Router with mains plugs
: Case
General functionality
: The sensor holders and extension straps are used to position the sensors on the patient. The sensors record
the patient’s movements and send the measured data to the base station via the router. The base station evaluates
the measured data from all the sensors and visualises the results on the graphical user interface, which is dis­
played in the iPad browser.
Functionality of the 743A250 Bionic Pro
The 743A250 Bionic Pro is intended for movement analyses when testing and comparing different orthoses. The
results of the measurements make it possible to provide objective evidence regarding which orthosis is most suit­
able for the patient.
: To carry out the measurement, the 743A250 Bionic Pro requires five sensors (one in the pelvic region, one
each in the heel region on both feet and one each on the lateral side of the thigh and lower leg of the leg to be fit­
ted).
: First, the patient walks along a straight course for 10 m without an orthosis. Then the measurement is repeated
with the orthoses that are to be compared with one another. The base station evaluates the results of the measure­
ments and displays the result in the graphical user interface in the browser of the iPad. The patient’s gait can
optionally be recorded with the iPad camera during measurement.
7 743A250 Bionic Pro
Product description