Otto Bock 743A250, Instructions For Use Manual

Page: 41 / 56

5.7.2 Fault table
FAULT PROBABLE CAUSE SUGGESTED REMEDY
Network cable not connected to
router
Identified by:
Right LED on base station not
illuminated
Plug network cable into WAN
socket on the router System has no Internet
Company network has no Inter­
net
Identified by:
Icon on router screen
Check company network
Contact administrator
Provide LAN socket without
proxy settings
Browser notification: “Page can­
not be opened” No WLAN connection
Identified by:
No WLAN icon can be seen in
menu bar
Connect iPad to WLAN
Switch on WLAN on iPad
Router is off
Identified by:
LEDs on sensors flashing rapidly
Centre LED on base station
flashing rapidly
Connect router to mains network
iPad connected to wrong WLAN
Identified by:
Tablet is not connected to Bionic
Pro router in WLAN settings
Connect iPad to the WLAN of
the Bionic Pro router
Base station switched off
Identified by:
LEDs on base station not lit
Connect base station to mains
network
Base station in configuration
mode (button on back accident­
ally pressed)
Identified by:
Centre LED (WLAN) on base
station flashing slowly
Unplug base station from mains
network for at least 3 seconds
and then plug back in again
Tablet screen remains dark Battery discharged
Identified by:
Tablet cannot be switched on
Charge tablet
Not all sensors are displayed in
system information Sensor switched off
Identified by:
Sensor not illuminated
Switch sensor on
Sensor battery drained
Identified by:
Sensor not illuminated
Charge sensor
WLAN connection to sensor lost
Identified by:
Sensor no longer illuminated
blue
Move sensor into range of router
Switch sensor off and on again
Sensor defective
Identified by:
Sensor not illuminated despite
previous steps
Contact service
Sensor is not being charged USB port dirty
Identified by:
Dirt in USB port
Carefully clean USB port with
compressed air (at 20 cm dis­
tance) or a vacuum cleaner
USB port defective Contact service
41 743A250 Bionic Pro
Use