Otto Bock 436P2 L1-7, Instructions For Use Manual

Page: 19 / 244

Fig. Article designation Quantity
Modular hand support, cone type, 200 x 130 x 90 mm 1
Modular hand support, cone type, 200 x 130 x 70 mm
1
Modular hand support, palm extensor, 235 x 165 mm 2
Modular hand support, palm extensor, 205 x 145 mm
1
Modular hand support, horn type, 190 x 145 x 90 mm 3
Modular hand support, horn type, 180 x 130 x 80 mm
1
Modular hand support, flat, 230 x 140 mm 4
Modular hand support, flat, 180 x 115 mm
1
Connecting rail 1 5
M6x6 set screw 4
5.2 Storage
Store the product in a dry, enclosed room with sufficient air circulation and
protection from external influences. Specific information about storage con­
ditions: see page 22.
6 Preparing the product for use
6.1 Installation
The hand support is mounted on the connecting rail of a modular arm sup­
port (436A2).
1) Slide the connecting rail (see fig. 5, item 1) halfway into the modular arm
support.
2) Slide the hand support fully onto the connecting rail and to the desired
position.
3) Firmly tighten the set screws of the connecting rail (see fig. 5, item 2) on
the underside of the modular arm support and the hand support.
4) Check that the hand support is securely attached.
6.2 Settings
The hand support can be adjusted for palmar/dorsal flexion by bending the
connecting rail.
7 Use
7.1 Using the product
The qualified personnel has already installed the hand support and adapted
it to the requirements of the user.
19