Otto Bock 17KF1 Series, Instructions For Use Manual, Page: 15 / 116

Drilling bars
Holes may be drilled in the bars.
►
Drill the holes for the mounting material in the bars. The distance
between the hole and the outer edge of the bar must be at least equal to
the diameter of the hole.
►
INFORMATION: The holes must not be repaired or filled under any
circumstances.
Installing mounting materials
► Install the mounting materials.
INFORMATION: Make sure that the mounting materials do not
obstruct the locking mechanism.
Final assembly of orthosis joint
► Use the 633F7 special lubricant to grease the metal.
► Secure the screw connection with Loctite 241.
INFORMATION
Delivery of finished orthosis to the patient
Prior to delivery of the orthosis to the patient, the fit, support and all func­
tions must be tested.
Pay attention to the parallel alignment of the orthotic joints.
Instruct the patient in handling the product.
6 Patient information
Inform the patient:
Inspect the orthosis for damage
►
Inspect the orthosis for damage daily. Contact the qualified personnel
promptly if changes are noted.
7 Cleaning
System joints must be cleaned promptly after contact with water containing
salt, chlorine or soap, or when they get dirty.
1) Rinse system joints with clean fresh water.
2) Dry system joints with a cloth or allow to air dry. Avoid exposure to direct
heat (e.g. from an oven or radiator).
15