English - 21 -
Problem: The water/compound mixture does not completely
drain from the work-container.
Cause: The waste-water hose is blocked.
Remedy: Remove the disc as described above and check if
the waste-water hose is blocked. Clean it if necessary.
Problem: The disc jams.
Cause: The gap between the disc and the work-container is
too narrow, the disc is badly worn or there are chips/work-
pieces jammed in underneath.
Remedy: Remove the chips or the work-pieces and check
the disc wear. If necessary, replace the disc.
Problem: There is water leaking out of a hole in the work-
container. (see picture)
Do not use the
machine any further
until the problem is
solved. Otherwise
there is the potential
danger of water entering the motor!
Cause: A seal is defective.
Remedy: Give the machine for repair to your dealer or di-
rect to Otec Präzisionsfinish.
