IET8242MPpH-S-DR
Hardened Managed 8-port 10/100/1000Base-TX(PoE+) + 4 port 100/1000Base-FX SFP
Ethernet Switch
4
Cable Connections
Signal Type
Cable Type
Connector
Ethernet
Cat. 5e or above
RJ45
SFP
Fiber
LC
Power supply
Power cable
Terminal Block
6. Technical Data
Power Connecting
The switch can be powered from two power supplies (input range 48V – 57V). Insert the positive and negative
wires into V+ and V- contact on the terminal block and tighten the wire-clamp screws to prevent the wires from
being loosened.
Connecting DC power cord
Note
：
The wire gauge for the terminal block should range between 18~20 AWG
DI/DO connecting
Connecting DI/DO Relay Wires
1. Insert the negative(ground)/positive DI/DO Relay wires into the +/- terminals, respectively.
2. To keep the DI/DO Relay wires from pulling loose, use a small flat-blade screwdriver to tighten the
wire-clamp screws on the front of the terminal block connector.
