Electrode Information:
Size: 88mm × 58mm × 3.2mm, 50.04 cm
2
Numbers: 4
5. STORAGE
Caution:
Do not store them in a damp area. Dampness may affect the device and cause rust.
- Operation condition: 5°C~40°C
20~65%RH
- Store and transport condition: 0°C~45°C (Note: small electrode pads 10 ~ 20°C)
10~90%RH
- The shelf life for small electrode pad under 10~20°C is 2 years
- The shelf life and service life for foot conductive rubbers and the main unit are both 5 years.
6. TROUBLE SHOOTING
Problem
Possible Cause
Solution
Page 28 of 37
Not placing both bare feet on the
foot-pads at the same time.
You may be dehydrated.
The intensity level may be too
low setting.
Your feet may be dry.
Ensure that your feet are bare and
each foot is placed on each of the
foot-pads at the same time. Keep
increasing the intensity up to a
maximum of 99 until you feel the
stimulation.
Moisturize the soles of your feet to
improve conductivity and stimulation
and try the procedure again. You
may also have to increase the
intensity level.
Drink plenty of water before and
after using the device. The device
uses your body to create the
electrical circuit. Water is an
excellent conductor of electricity and
if your body is less hydrated (below
60%) then the stimulation may be
less. Therefore it is important to
always remain well hydrated.
This is a very safe device. Keep
increasing the intensity level
towards 99 until you feel the
stimulation. You may find that you
have to increase the intensity level
as you get used to the therapy. The
aim is not to get to 99 but to find a
setting that is comfortable for you.
OSITO electronic
stimulator is on
(lights illuminated
on the LED display)
however the
user cannot feel the
electrical stimulation
through the foot pads.
