9
2. Remove the jar from the base and free the blade of any obstructions.
3. Wait 30-45 minutes for the unit to cool.
4. Press the resettable fuse button located on the bottom of the base.
2. Jar Sensor on base released
1. To restart the unit, turn control knob to “OFF“ position.
2. Make sure the jar is securely placed on the blender base.
3. Restart the blender by turning the control knob to the desired setting.
If the warning light flashes and the motor will not run with the jar in place,
the unit has not cooled sufficiently. Turn the control knob to “Off” and wait
another 10-20 minutes before trying again.
Caring for Your Product
Cleaning
Base: First turn the control to “Off” and unplug the power cord. Then wash
outside surface with a damp soft cloth or sponge using mild soap and warm
water. Never immerse the motor base in water or other liquid.
Jar: Fill the container half full with warm water and add 2 drops of liquid soap.
Close the jar with the lid and filler cap. Turn Speed Dial to a “Low” speed and
then increase to “High”. Run for 30-60 seconds. Turn the machine OFF, rinse
the jar out with running water then dry.
Lid & Filler cap: Separate the 2 pieces and wash in warm soapy water. Rinse
clean under running water, then dry.
NOTE - Do not put lid, filler cap or jar in the dishwasher.
Storing
After cleaning, store with lid not closed completely to allow air to circulate and
prevent container odors.
WARNING: Never put the jar or any other parts in a microwave.
Never store foods or drinks in the jar.
BLSTVB-000-033_13EFM1.indd 9
10/8/13 11:05 AM