Forgotten dishes can be added at any time before opening the dishwasher compartment.
If this is the case, follow these instructions:
1 Open the door slightly to stop the appliance.
2 When the sprinkler stops turning, you can open the door completely.
3 Add the forgotten dishes.
4 Close the door.
5 Press the START/PAUSE button to start the dishwasher.
1 Remove the basket.
2 Fill a suitable dishwasher.
3 Connect the plug to the power outlet.
4 Press the power button to turn on the appliance.
5 Connect the drainage pipe to the tap and make sure that the water supply is full or
add the water manually to the tank.
6 Select the desired program. When you select a program, the corresponding indicator lights up.
7 Press the START/PAUSE button to start the dishwasher.
NOTE
: When you press the START/PAUSE button to pause the wash, the program indicator stops flashing.
The dishwasher beeps every minute until you press the start/pause button again.
A running program should only be changed immediately after the start. Otherwise, it is possible that the
detergent has already dissolved and the dishwasher has been loaded with water. If this is the case, refill
detergent. Press the Start/Pause button to pause the machine. Keep the button pressed down with the door
closed for more than three seconds to set the new program.
English-11
EQUIPMENT MAINTENANCE
Start the washing process
Program Change
Display indicators
The display shows the status of the appliance and the cycle as follows:
Indicator
Status
-:--
The device is in standby mode.
The indicator does not blink. Pause
The indicator is blinking. Washing cycle in progress
The device is in standby mode.
H:MM
H:MM
END
NOTE:
If you open the door while the appliance is running, it stops automatically. If you close the door
again and press the Start/Pause button, the appliance will continue to operate after 10 seconds.
Adding dishes later
Summary of Contents for OS-DWMIT
Page 1: ...OS DWMIT ...
