www.oster.com
www.oster.com
8
9
CARE & CLEANING
Cleaning Your Electric Can Opener
CAUTION: UNPLUG THE CAN OPENER WHEN NOT IN
USE AND BEFORE ANY CLEANING
CAUTION: Never immerse the can opener, cord, or plug
in water or other liquids.
CAUTION: Blade is sharp, handle with care when
removing or installing parts, when cleaning, and
especially around children. Do not allow children access
to the lever.
•
To insure proper sanitation, all removable parts on the
can opener should be detached and cleaned thoroughly
in warm, soapy water at regular intervals. Rinse and
dry thoroughly.
•
To clean motor housing, wipe clean using a damp cloth.
•
Wipe off drive wheel with a damp cloth.
NOTE:
DO NOT
place any parts of this unit in the dishwasher.
Removable blade assembly
Blade assembly can be easily removed for cleaning and
replaced when done.
1 To detach the can opener lever from the unit
a. Gently lift the can opener lever to the upright position
b. Hold the can opener with one hand while gently
pulling the can opener lever away from the front of
the unit with the other.
2 To re-attach the can opener lever back on the unit
a. Hold the can opener lever in the vertical position.
b. Insert shaft into the key hole near the drive wheel
and push the lever in all the way.
c. Rotate the can opener lever clockwise until
it is horizontal.
NOTE: If lever is properly engaged, it cannot be removed
from the can opener when in horizontal position.
HINT: Cutting mechanism may collect food or paper from
can labels and should be washed frequently.
Maintenance
The motor and internal gears of your can opener unit are
permanently lubricated at the factory for lifetime service
and require no further attention. The cutting blade is made
of hardened steel and will last for years under normal use.
Do not attempt to sharpen.
This appliance has no user serviceable parts. Any servicing
beyond that described in the Cleaning Section should be
performed by an Authorized Service Representative only.
See Warranty Section.
FPSTCN2000_20EM1.indd 8-9
FPSTCN2000_20EM1.indd 8-9
12/4/20 10:19
12/4/20 10:19
