Össur REBOUND ROM, Instructions For Use Manual

Page: 5 / 38

5 PB
b. Strap 3 Note (long version only): With the knee in slight flexion, press
the hinges slightly posterior. When tightening, ensure the strap is first
drawn around the back of leg with moderate tension and press down
on the contact fastener. Continue wrapping the strap through the
corresponding d-ring. Draw the strap snug and press down the
contact fastener.
c. Straps 4 & 5 Note (long version only): Individually tighten straps 4
and 5 to fix the hinge position mid-line on the leg. Strap length can be
adjusted from both ends of the strap
(Figure 5) .
d. Remove yellow strap tab: Once all straps are adjusted and fastened as
desired, remove the yellow strap tab behind strap 2 to secure.
PATELLA CONTROL
Patella buttresses are located within the patella opening of the knee
brace. Remove buttress from inside of the brace and attach in desired
position.
3. RANGE OF MOTION ADJUSTMENT (ROM)
Adjustment should be performed by a health care professional. The brace
comes with 10° extension stops attached to the hinges. If needed, ROM
control can be adjusted using the Extension and Flexion stops included
with the brace. Extension stops are labeled 0°, 5°, 10°, 20°, 30° and 40°.
Flexion stops are labeled 0°, 45°, 60°, 75° and 90°.
ADJUSTING THE ROM:
a. Remove extension stop retaining screws. Using a screwdriver or pen,
slide the 10° stop out of the hinge on both sides (Figure 6a) .
b. Re-apply the desired extension stop and gently secure it with the
retaining screw (do not over tighten) (Figure 6b) .
c. Follow the same procedure for the addition of a flexion stop.
WASHING INSTRUCTIONS:
1. Remove hinges and close all hook/loop fasteners before washing.
2. Hand wash using 30 °C (86 °F) soapy water. Rinse thoroughly and line
dry only.
3. Do not machine wash or dry.
4. For best results, rinse after every use.
Materials: Nylon, Elastane/Spandex, Nylon, Polyester