Osram HF LS LI, Installation And Operation Manual, Page: 11 / 28

11
3 Function and settings
3.1 Master Remote remote control (

separate instructions)
3.2 Manual configuration of detection range
1. Press the [PROG] button (VLP) to start programming mode.
2. Press button [3] of the inner ring segment (SP) for manual configuration of the detection
range. This automatically sets the range to the mean value.
3. Modify the range according to the table below by pressing (SP) the buttons [4], [5] and [7]
to [14].
4. Exit manual configuration by pressing (LP) the button [PROG] or automatically 60s after the
last detected motion.
Detection sensitivity / range Button action
-5 (minimum) Press button [5] (SP)
-4 Press button [7] (SP)
-3 Press button [8] (SP)
-2 Press button [9] (SP)
-1 Press button [10] (SP)
0 (mean) Press button [3] (SP)
+1 Press button [11] (SP)
+2 Press button [12] (SP)
+3 Press button [13] (SP)
+4 Press button [14] (SP)
+5 (maximum) Press button [4] (SP)
Table: Detection sensitivity settings
Testing detection sensitivity:
1. Press the [PROG] button (VLP) to start programming mode.
2. Select test mode by pressing (SP) the [6] button.
3. Start test mode by pressing (SP) the [PROG] button.
4. Test mode of control unit for 60 seconds: Lighting (maximum) as soon as motion has been
detected. Change 1s after the last movement back to minimum. Test mode duration is reset
to 60 seconds after each movement.
5. Exit test mode by pressing (SP) the [PROG] button or exit automatically 60 seconds after
the last detected movement.
Switch off delay test
Sensor
select
ON
OFF
30 sec
3 min 5 min
1 2
10 min
15 min 30 min 60 min
1 sec 1 min
Macro Recorder
100 h
Burn-in
CH-1 CH-2
PC modes
Offset
PROG
Auto
setup
Manual
setup
Semi
Auto
Semi
Auto
OFF OFF
Mee
tin
g-/
Clas
sro
om
Sin
gle
Offi
ce
Sa
ni
ta
ry
Ro
om
O
pe
n-
pla
n
Offi
ce
Corridor
Staircase
ON
OFF
ON
OFF
Stand-by-level
Stand-by-time
OFF
ON ON 5 min
10 % 30 %
30 s
30 min 15 min
60 min
50 %
1
7
8
13
14
10
11
4
6
9
12
2
5
3
17
18
16
15
19
20