OSRAM GmbH
Kunden Service Center
Customer-Service-Center (CSC)
Steinerne Furt 62
86167 Augsburg
Germany
Tel : +49 (0) 1803 677 - 200
(kostenpflichtig / charges apply)
Fax.: +49 (0) 1803 677 - 202
www.osram.com
www.osram.de
40083214217394
4008321421739
Page 1 of 2
Hand-held transmitter
Fitting instructions
VIII 2009
EASY-Hybrid-Remote_ma0908en_we1.01.indd
EASY Hybrid Remote
A
B
F2
C
D
E
G
F1
F4
F3
J
K
1
2
3
4
5
6
7
8
A
B
C D
IR
LEARN
SETUP RF
5
B
L
L
M
N
P
O
Description
Function
The EASY Hybrid Remote hand-held transmitter is used
together with an EASY IR infrared receiver or an EASY RC
radio receiver for the setting and functional control of connected
EASY control units. The hand-held transmitter can be used to
operate up to 8 channels, 8 lighting scenes and 4 sequences of
a lighting system and to set the brightness, light colour and col
-
our temperature. The power supply is provided via commercially
available batteries. If the hand-held transmitter is mounted in a
wall bracket, an external power supply can be used.
Design
The hand-held transmitter is made up of the following compo
-
nents:
•
Infrared window (A)
•
Display (B)
– Infrared transmission (1)
– Radio transmission training mode is activated (2)
– Battery status display (3)
– Transmission is active (4)
– Setup menu is activated (5)
– Radio transmission (6)
– 10-digit dot matrix display (7)
•
Central button (C)
• Jog wheel (D)
•
Scene buttons (E)
• Function buttons (F1, F2, F3, F4)
• Sequence buttons (G)
• DIP switch in battery compartment
•
„Connect“ button in battery compartment
Installation
Safety instructions
The wall bracket must only be installed and put into operation
by a qualified electrician. The applicable safety regulations and
accident prevention regulations must be observed.
CAUTION!
Destruction of the hand-held transmitter and other
devices through incorrect mounting!
• Adhere to the connection diagram.
• Do not wire the EASY bus terminals with an
external voltage, especially not a mains voltage
of 230 V.
• Only connect the supply terminals to a DC volt
-
age of 10-24 V.
• Only use batteries of the specified type.
• Only work on the hand-held transmitter when it
is de-energised.
Attaching the wall bracket
Note: A flush-mounted box is needed for connecting the EASY
bus. For the combined EASY bus and DC supply connection, a
flush-mounted box with twice the depth is needed if the power
supply unit is to be placed into the flush-mounted box behind
the wall bracket.
Attaching without a flush-mounted box
Loosen the cover screws (L) on the back of the wall bracket
and remove the cover.
Loosen the printed circuit board screws (M).
Remove the board in the lower part of the wall bracket and
keep it in a safe place.
Reattach the cover and fix it with the screws (L).
Attach the mounting plate (N) on a level surface.
Mount the wall bracket on the mounting plate from above.
Fix the wall bracket from below with the supplied mounting
screws (O).
Hand-held transmitter as a permanent wall operating unit
(optional): Fix the hand-held transmitter from below with the
supplied fixing screws (P).
