Page 2 of 2
10-24 V DC
-
+
+
-
1
2
3
4
Easy Signal
DALI EASY III
L
N
GND (-)
CH4+ (W)
CH3+ (B)
CH2+ (G)
CH1+ (R)
Easy signal
24 V (+)
CH1 (R-)
CH2 (G-)
CH3 (B-)
CH4 (W-)
GND (-)
OT EASY 60 II
L
N
Y-Connector
Screw
1
2
3
4
N
R
Q
Connection diagram
N Mounting plate on the back of the wall bracket
Q DC supply (optional)
R EASY Bus connection (optional)
Attachment on flush-mounted box and
optional electrical connection
Shorten the connection wires so that they protrude approx.
5-6 cm from the flush-mounted box.
Strip the required connection wires by approx. 5 mm. Insu
-
late any connection wires not needed.
Pass the required connection wires through the centre open
-
ing of the mounting plate (N).
Align the mounting plate (N) and attach it to the flush-
mounted box. Ensure that it is seated securely, sliding the
mounting plate up or down or to the left or right by a few
millimetres if necessary.
Optional: Connect and test the DC supply:
CAUTION!
Destruction of components connected to EASY bus!
• Do not connect the DC supply to the EASY bus.
Connect the supplied 2-pin plug-in connector to the DC
power supply and plug it into the corresponding socket (Q)
on the back of the wall bracket.
Test: Take the batteries out of the hand-held transmitter and
switch on the DC supply. Insert the hand-held transmitter
into the wall bracket from above and press down.
à
The LCD lighting must light up. Switch off the DC supply.
Optional: Connect the EASY bus after the DC supply test
was successful.
Connect the supplied 4-pin plug-in connector to the EASY
bus wires and plug it into the corresponding socket (R) on
the back of the wall bracket.
Bend away the connecting wires in an S-shape and place
the wall bracket onto the mounting frame from above. En
-
sure that the wires do not press against the wall bracket and
are not pinched.
Attach the wall bracket using the supplied mounting screws
(O).
Hand-held transmitter as a permanent wall operating unit
(optional): Fix the hand-held transmitter from below with the
supplied fixing screws (P).
Appendix
Accessories
Note:
The accessories are not included.
Designation
Description
Product number
Y-CONNECTOR screw
Y-connector with screw terminals
for EASY signal connection with
4-pin cable
4008321916686
OT 6/200-240/24
24 V power supply unit for flush-
mounted box installation,
power supply range 220-240 V
4008321113269
Disposal
Do not dispose of the device and batteries with
household waste.
Electronic devices must be disposed of at local
recycling centres for waste electronic equipment in
accordance with EU Directive 2002/96/EC on waste
electrical and electronic equipment.
Installation (cont.)
Conformity with the relevant EU directives is
confirmed by the CE symbol.
