POCO AG
™
SERIES
4
3.1
Release the Double Halo™ child
harness by pressing the red button
at the front of the cockpit.
3.5
To move the seat down, pull up
the red webbing loop up located
at the base of the child’s head
rest and while holding the
webbing loop up push the seat
down to the desired position.
3.6
Place child in the child carrier guiding
one leg through each of the Double
Halo™ leg loops in the child seat.
Ensure the child’s chin is level with
the top of the drool pad for proper fit.
3.10
To loosen the child harness, pinch
the buttons at the ends of the
harness buckles and pull chest pad
away from the child.
3.7
Unclip the child harness from the
plastic webbing keepers mounted
on the rear handle. Guide the child’s
arms through the Double Halo™ arm
loops of the harness.
3.11
Use the stirrups for children at
the top of the stated weight range
requirements in this owner’s manual.
Place feet in stirrups and adjust
the stirrup height so the child’s
knees are slightly bent to prevent
circulation deprivation.
3.8
Insert the right and left harness
male buckles into the dual sided
female buckle located on the
chest pad.
3.2
Slip both child harness straps
into the plastic webbing keepers
mounted on the rear handle. This
keeps the harness straps out of the
way to make it easier to place the
child in the carrier.
3.3
For proper fit, the child’s chin should
be level to the top of the drool pad
at the front of the cockpit. Place
the child in the carrier to check if
adjustment is needed.
3.4
To move the seat up, grab the red
handle at the back of the seat and pull
up and the seat will automatically lock
into position
WARNING Child must not be in the
carrier while adjusting seat height.
3.9
Cinch down both right and left
straps so that the harness is snug
around the child’s upper torso. The
child is now secure in the cockpit.
PREPARE THE CHILD COCKPIT BEFORE
PLACING THE CHILD IN THE CARRIER
ADJUST CHILD SEAT HEIGHT
SECURE THE CHILD
ADDITIONAL CHILD FITTING TIPS
ASSEMBLY
3. FIT AND SECURE THE CHILD
To adjust the seat, follow these steps:
