10
5.1 Settings
The product does not require any special set-
tings.
5. USER GUIDE
6.1 Faults and fixes
If problems arise when the product is in use,
check for these possible faults:
1. Water leaking from pipe connection. Pos-
sible cause: Pipe connection is loose or
sealant is insufficient. Possible solution:
Tighten pipe connection, replace sealant
if necessary.
2. Water leaking from the tank, not the pipe
connection. Possible cause: Leakage from
the steel tank. Possible solution: Check if
it is possible to see the leak point. Con-
tact installer.
If you are unsure what is wrong, contact the
installer (see product type plate) or OSO Hot-
water AS - see section 7.1.
6. TROUBLESHOOTING
4.1 Filling with water
First check that all pipes are connected correctly.
Then proceed as follows:
A) Open for venting at a point in the system
higher than the top of the tank; use e.g. the
3/4” top connection on the product.
B) Open the water supply to the product.
When water flows out of the venting point, the
tank is full and the vent can be sealed.
4.2 Control points
A) Check that all pipe connections to/from the
product are tight and not leaking.
B) Check that the product is standing firmly ver-
tically and horizontally.
4.4 Handover to end-user
4. INITIAL COMMISSIONING
THE INSTALLER MUST:
Brief the end-user on safety and maintenance
instructions.
Brief the end-user on settings and emptying the
product.
Hand this installation manual over to the end-
user.
Enter contact details on the type plate on the
product.
!
WARNING
The water temperature in the product may ex-
ceed 75°C and could cause scalding. So take
great care when emptying the product.
A) Shut off/disconnect from the heat source.
B) Close the incoming water supply.
C) Open fully for venting – leave open (prevents
vacuum).
D) The product is emptied by disconnecting
the lower return valve (1). Product emp-
tied. After emptying, the lower return valve
should be reconnected and the vent closed
before the product is refilled.
4.3 Emptying of water
1
