OSO HOTWATER 1327051, Installation Manual

Page: 3 / 24

3
Safety instructions
• Read the following safety instructions
carefully before installing, maintaining or
adjusting the water heater.
• Personal injury or material damage may
result if the product is not installed or
used in the intended manner.
• Keep this manual and other relevant doc-
Safety instructions for installers
! WARNING
The overflow from the safety valve must NOT be sealed or plugged.
!
Discharge must comply with current building regulations.
!
Fixed electric fittings shall be used for installation in new homes or when changing an
existing electrical setup in accordance with regulations.
!
The mains cable shall withstand 85°C. A strain reliever must be fitted.
!
The product shall be filled with water before the power is switched on.
!
The relevant regulations and standards, and this installation manual, must be followed.
Safety instructions for users
!
WARNING
The overflow from the safety valve must NOT be sealed or plugged.
The product front and electric junction box must NOT be covered
The product must NOT be modified or changed from its original state.
Children must NOT play with the product or go near it without supervision.
!
The product shall be filled with water before the power is switched on.
!
Maintenance/settings shall only be carried out by persons over 18 years of age, with suf-
ficient understanding
! CAUTION
The product must not be exposed to frost, over-pressure, over-voltage or chlorine treat-
ment. See warranty provisions.
Maintenance/settings shall not be carried out by persons of diminished physical or men-
tal capacity, unless they have been instructed in the correct use by someone responsible
for their safety.
! CAUTION
!
The cylinder must be installed in compliance with current building regulations. Liability for
consequential damage will only apply if this is followed.
!
The product shall be properly aligned vertically and horizontally, on a floor or wall suitable
for the total weight of the product when in operation. See type plate.
!
The product must have a clearance for servicing of 400 mm in front of the immersion cover
/ 150 mm above the highest point.
Do not use the balanced cold connection to feed any outlets other than mixer showers.
Under no circumstances use the balanced cold connection to feed all cold water outlets as
this practice contravenes Section 10 of water regulations.
uments where they are accessible for fu-
ture reference.
• The manufacturer assumes compliance
(by the end-user) with the safety, oper-
ating and maintenance instructions sup-
plied and (by the installer) with the fitting
manual and relevant standards and regu-
lations in effect at the date of installation.