Printing
●
The enclosure models are pretty big and so can be
prone to warping or curling up from the print bed over
time. Minimize that risk by using a filament with low
shrinkage like PLA and ensuring good bed adhesion.
●
The keys have hinges that fragile. Remove them gently
with a scraper tool if they’re stuck to the bed.
Post-printing
1. Clean up strings
a. Cut or melt away any stringing. Be careful not to
scratch dark filament underneath text
embossing
2. Remove built-in supports
a. Break built-in bridge supports from each PCB
post with a small screwdriver or other stabby
object
b. For the OKAY 2, do the same for the key cradle
3. Knobs
a. Cut built-in bridge support from bottom to
expose shaft cavity
b. One knob has a hole in its side. This is a cavity
for the brass threaded insert, which you’ll lock
into place by inserting with a hot soldering iron
Summary of Contents for OKAY 2 Synth
