13
1.
Remove your OSET & Accessory pack from the box and check contents against the
following list:
1x Accessory Box containing:
1x Battery charger c/w power lead & manual
1x Number board
4x Black cable ties
1x Hex Key set (Allen keys)
1x Spanner (8 & 10mm)
1x Manual for disc brakes (Not applicable for 12.5 Eco)
1x Manual for rear shock
2.
Place your OSET on a solid & level stand, with both wheels off the ground.
3.
Remove all the packing materials.
4.
Using the supplied Allen keys, make sure the steering stem is in the forward facing
position and tighten the top and side bolts securely and evenly.
Secure the handlebars tightly in the steering stem. Double check tightness and
alignment. Adjust the brake lever positions and reach to suit the rider.
See page 22.
UNPACKING AND ASSEMBLY
Failure to properly assemble and adjust your bike prior to use may result in an
accident resulting in death, serious injury and/or property damage. If you are uncertain
about any aspect of the assembly and adjustment of your bike, seek help from a qualified
mechanic or the OSET Customer Service Department.
WARNING!
There are no user serviceable elements incorporated into the motor, motor controller,
batteries, battery charger, throttle, or wiring harness of your OSET electric bike. DO NOT
ATTEMPT TO DISASSEMBLE OR ADJUST ANY OF THESE COMPONENTS. Doing so may cause
extensive damage to these components, will void your warranty, and may cause a
hazardous condition. If you cannot resolve a problem using this owner’s manual, contact
your OSET authorized dealer, or call the OSET Customer Service Department for
assistance.
WARNING!
NOTE
If you purchased your OSET at a local retailer your machine may be fully adjusted and ready
to ride. If you purchased your OSET in the carton, please carefully follow the instructions
below and any supplemental instructions to finish the assembly and adjustment of your
OSET.
14
UNPACKING AND ASSEMBLY
For setting up a
12.5 Eco,
please follow step
5
.
For setting up a
12.5 Racing
, please follow steps
6
-
8
.
5.
12.5 Eco:
The 12.5 Eco is fitted with a front V
-
brake and a rear band brake. Both
brakes will already be connected; they may need some minor adjustment.
Please see
page 22
. Now skip to point 9 to continue setting up our OSET.
6.
12.5 Racing:
-
Loosen top calliper Allen bolts with a 5mm hex key
-
so it will move
side to side (
picture 1).
7.
Spin the front wheel and apply the front brake. Do this twice. While holding the front
brake on
-
tighten calliper bolts. This will centre the calliper and help to give even
wear of the pads and free running of the front wheel.
8.
Adjusting rear calliper. Ensure rear wheel is clear of ground and turn by hand and
check brakes are not binding if they are loosen cap screws and adjust. Be aware that
because the wheel can be moved back and forth for chain adjustment the calliper
does also
-
so make sure it does not rub on the outer diameter of disc.
9.
Install the front number plate using the supplied ‘zip
-
ties’. This attaches below the
handlebars and to the forks
(picture 2).
(1.)
(2.)
(3.)
10.
Check tire pressure of both tires and confirm they are properly inflated to
20
-
40 psi
.
Light riders can use lower pressures.
11.
Batteries are placed in the bike for shipping purposes, but they will need connecting.
It is vital that connections are made correctly. The battery strap should be fitted
before connecting the main battery leads. Install the batteries as indicated
(picture 3).
12.
Unpack charger from its box and read manual. Charge the batteries while thoroughly
reading the complete owners manual.
See page 25.
13.
Compress and check each brake lever in turn. The lever should not compress
completely to the bar. Each individual brake should hold the bike securely when you
push the OSET against the brake. If your brake needs adjustment, follow the
instructions on
page 22
. Learning riders should be aware which lever operates which
brake.
14.
For maximum battery life, always fully charge before operating your OSET for the first
time and never store with discharged batteries
15.
While your batteries are charging, please Read Your Owners Manual completely.