Page 26
Installation and Operation Manual - Matrix
ENGLISH
6.4.1 Adjustment
To facilitate access to the door lock mechanism, the decorative panels on the left side of the
appliance should be removed (see
«Appendix 1: Side Panels Installation»
). Otherwise, the bolts
are accessible with an open wrench 3/8".
Unscrew the top and bottom bolts
(A)
to adjust the depth of the lock, the tension on the door
and on the gasket. Unscrew the left and right bolts
(B)
to adjust the angle of the door handle.
Unscrew the bolts on the door handle
(C)
to align the ball bearing with the handle.
6.4.2 Gasket
It is important to replace the gasket with another having the same diameter and density to
maintain a good seal.
1. Remove the door and place it face-down on something soft like a cushion of rags or a piece of
carpet.
2. Remove the old gasket from the door. Use a screwdriver to scrape the old gasket adhesive from
the door gasket groove.
3. Apply a bead of approximately 3/16" (5 mm) of high temperature silicone in the door gasket
groove. Starting from the middle, hinges side, press the gasket into the groove. The gasket must
not be stretched during installation.
4. Leave about ½" long of the gasket when cutting and press the end into the groove. Tuck any loose
fibers under the gasket and into the silicone. Close the door. Do not use the stove for 24 hours.
A
C
F
G
B
Summary of Contents for MATRIX OB02032
Page 2: ......
Page 6: ...Page 6 Installation and Operation Manual Matrix ENGLISH CERTIFICATION PLATE...
Page 55: ......
