- 5 -
ASSEMBLY INSTRUCTIONS
1. Check that all parts are included as listed.
2. Insert the cross nut bolts (11) into the holes provided in the wooden struts (4). Make sure that the slots
of the cross nut bolts are facing upwards.
3. Connect the wooden struts (4) and the left foot (1) by inserting a long met-
al screw (9) through the lower opening of the foot (1) and tighten it with the Allen key (12)
.
4. Now connect the wooden struts (4) to the right foot (2). Do not fully tighten the metal screws.
5. Connect the metal rod (3) and the left foot (1) by inserting a short metal screw (10) through the centre
hole of the foot and tighten it with the Allen key (12). Do not yet attach the metal rod (3) to the right foot
(2).
6.
Lay the backrests (5 & 14) with their backs facing upwards on a fl at and clean fl oor. Insert the remaining
two cross-nut bolts (11) into the pre-drilled holes in the backrests (5 & 14). Make sure that the slots of
the cross nut bolts (11) are facing upwards.
7. Connect the backrests (5 & 14) to the left foot (1) by inserting a long metal screw (9) through the upper
opening of the foot and then tighten it with the Allen key (12). Do not yet attach the backrests to the
right foot (2).
8. Insert the safety bar (8) between the two feet (1 & 2). If necessary, pull the right foot (2) slightly to the
side. Attention: The wooden dowels at both ends of the safety bracket (8) must be inserted into the
holes provided on the insides of the feet. Pull the crotch strap through the opening in the seat (6) and
into the slots provided in the backrest (14).
9. Now connect the backrests (5 & 14) and the right foot (2) by inserting a long metal screw (9) through
the upper opening of the foot and then tighten it with the Allen key (12). The safety bar is now fi rmly in
place between the two feet.
10. Slide the seat (6) and the footrest (7) into the notches at the desired height. Make sure that both plates
are parallel. Now tighten all screw connections fi rmly.
11.
If the height of the seat (6) and footrest (7) needs to be adjusted, it is suffi cient to loosen the strap and
loosen the upper and the middle screw on one side. Slide the panels in at the new desired height and
tighten all screws again.
NOTE
Only the upper two notches for the seat are intended for use with the safety bar, crotch strap and harness
system.
EN
